Hi my wwa7304v top loader washer does not agitator. Does everything else spins, drain water but when it starts teh agitator cycle it makes a loud noise pumps water but does not agitator
To check the agitator. Start the washer into wash cycle. Once started Push down on top of agitator. If it catches some times or all of the time when pushing down, then then doggets are worn, under the agitator. You`ll have to remove the agitator to see these. If by pushing down on the agitator, nothing changes, Then you probably have a transmition problem. Check this and let me know what you find.
I don`t have a pic I can send you. Tried to find a diagram but unable to. There should be a bolt head under the cap on top of the agitator. Losen this bolt. You should be able to remove the agitator now. Sometimes they are hard to get off. On top of the spline, inside of the agitator the is a agitator coupling. Check this for ware and also check the spline. My guess is the agitator coupling is bad. Replacing the coupling and agitator are pretty much in reverse. Let me know if you have any trouble.
I am glad that I was able to help you. If you need any more help, please do not hesitate to post. I well help you as much as I can.
×
GE washer approx 20 yrs old..will fill up but this morning will not wash. It will empty the water though. I've been also having problems with it lately with regards to not spinning fully and have had to reset to spin after each wash cycle.
Please also provide quote on repairs and whether better to buy new versus repairs.
Thanks so much!!!
dee
2,171 views
Usually answered in minutes!
done that found out the doggets are worn and gone in the agitator
order one but how do you get it out of the agitator. I removed the cap. any instructions.???
Is there any pictures, diagrams or detail instructions how to remove the doggets spline from inside the agitator??
Did get the agitator off with no problems, on this ge unit all you have to do is pull up. The spline itself is ok. Cannot get the coupling out of the agitator. 20 Years old. The coupling is worn inside only thing left is the top grooves none inside.Was able to order a complete agitator with coupling already assemble. Best price was from A-1 Appliance parts and the next best price was acturally directly from GE. Thanks for the help. A-1 applicance also has a great link to free repair manual with a pix. Trouble is the coupler is so old. Glad I found one already assemble in the agitartor
My fisher & pykel machine has the same problem. All lights work fine, pumping and spinning except the agitator is not washing. Mode MW612nz.
Can you please help, thank you .
Old top load Whirl pool. Over 10+ years old. Does not agitate. Everything else seems fine. The bottom part agitates (the part that spreads out over the bottom.....but not the rest. Pushed down on agitator during wash cycle but nothing happens. What else can I do?
My washer is about 10 years old and the agitator does not work. It fills up and spins. I tried to take it apart, but only see 4 plastic knobs inside the top part of the agitator. I am thinking somethink might be stuck down in it, not sure.
×