Kenmore Elite 24952 topload washer stops after rinse before drain

The cycle controller

The lid switch controls the rinse and spin cycles.
If the lid switch is bad the cycle fails to advance.
Replace your lid switch.

go to appliancerepairplanet.vstore.ca for a suppot

lid switch stops machine from spinning when the lid is open, Make sure the lid is fully closed. Loose screws on the lids right side not holding metal arm properly, or the arm is not positioned properly (the end which is pointed down when the lid is open needs to be slightly farther away from you, towards the back of the machine, to actuate the switch fully: or the lid switch itself which is underneath the top,

check the lid swetch

It sounds like your lid switch is bad . Raise the lid , and insert something into the lid switch hole on the top ( where the lid actuator goes into the hole ) , to see if the washer drains . Without your complete model number , can't give you a part number .

Sounds like not spinning.
First check the lid switch.
Manually set the timer for spin and turn it on.
Open and close the lid.
If no spin replace the direct drive coupling on the motor.
About a $30 part.

do you hear a clicking noise when you close the lid if not check your lid switch

it is a problem with the lid switch. check for continuity. if the lid is close , it should have continuity, if you open the lid, it should be open also.

tnx 4 using fixya,

drcool

If your timer is stopping at the drain cycler (before the rinse) check the LID SWITCH. Most washers will not drain or continue the cycle if this switch is not closed. Open the lid and look for an opening in the housing were the lid sits. try depressing it manually while the timer is at the drain cycle.