I have a hotpoint aquarius wt540, it stops working 2nd and 4th led start flasihing along with the power led, i have opened the back of the machine and checked the pipes nothing is blocking them, seems to make a funny noise when pumping in water, but theres water in the drum so im not sure
barry low
Hiya Barry, I have the same machine and for the last 3 days have had the exact same problem...mini load and reduced crease as well as power light flash right when it comes to drain...?
I have scratched my head and done lots and lots of research, reckon I could design and build my own washer now lol, anyway, I fitted a new pump and ran it, thinking this is it sorted, went out and got a call from our lass...doing it again.
Right, gonna have to get me hands dirty...I removed the drain hose (Ignore the pump for a second, I'm talking about the grey hose that goes from the pump to the sink) from the sink and poked my fingers as far as they would go...debris, I then removed it from the other end (Pump) so I had a long hose in my hands, not attached to anything at either end....cleared it and again, loads of debris (Fluff, plastic etc) and put it all back together...turned the old fella back on and running a wash right now as we speak...happily spinning round at 1400rpm and throwing gallons of water down the sink...I would consider it fixed.
So I can most definately tell you that you have a blockage somewhere mate, I'd get your hands in the toolbox and pull that pipe off, doesn't require any level of experience, just the ability to put things back as you found them...
Hope that helps
1,487 views
Usually answered in minutes!
Power light and two other lights flashing. pump running nothing else. Water drains tried putting three kettles of cold water in drum and drained out. Any ideas
Machine works well apart from very very noisey spinning sounds if something needs greasing or oiling
×