Tax Rate How do you change the pre-programmed tax rate on the calculator? It is set at 5%, but I would like to change it to 6%. Please help me!

How do I program tax rate into my calculator?

Non-printing models (also applies to HR-8TE printing calculator):

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]


Printing models (except HR-8TE):

1. Have calculator in "print" mode
2. Press [CA]
3. Hold [SET/%] key for about 3 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

press AC
press RATE SET, hold for approx5 secs till you see "tax" "%" displayed
type in new rate (say 20)
press RATE SET (to confirm 20% as new tax rate)

Done

From CASIO FAQs:

How do I program tax rate into my calculator?

Non-printing models (also applies to HR-8TE printing calculator):

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

http://www.casio.com/support/content/AF64A1AC-193D-4650-A9A9-98BB6FE26CFE#0

How do I program tax rate into my calculator?
Non-printing models (also applies to HR-8TE printing calculator):

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]


Printing models (except HR-8TE):

1. Have calculator in "print" mode
2. Press [CA]
3. Hold [SET/%] key for about 3 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

SETTING YOUR TAX RATE
you hold your set % button down for three seconds until set shows again, then hit tax rate button it shows your tax rate, change your tax rate then hit set your tax rate should be set.



cliff notes:
hold set% button
hit tax+ button
change the desired % 
hit set done


Do rate the solution.

How do I program tax rate into my calculator?
Non-printing models (also applies to HR-8TE printing calculator):

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

I found this on the Casio site. I think yours is a printing model. If it is use the 2nd set of instrucitons. Hope it works...

Programming Tax Rate
Non-printing models (also applies to HR-8TE printing calculator):
1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

Printing models (except HR-8TE):
1. Have calculator in “print” mode
2. Press [CA]
3. Hold [SET/%] key for about 3 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

1. Switch off the calculator
2. Switch it on again
3. Press and hold the tax button (set %) until the display changes
4. Enter the new tax rate
5. Press the tax button (tax +)

Any problems contact [email protected] - he emailed the solution to me and it has worked.

Pam

Printing models (except HR-8TE): 1. Have calculator in ?print? mode 2. Press [CA] 3. Hold [SET/%] key for about 3 seconds 4. Input the tax rate 5. Press [TAX+] 6. Press [SET/%]