Hello, We have a Zanussi ZDT6252 Built-In Dish Washer and lately is stops after approx. 5 mins on the 'Rinse & Hold' status. We have to turn off the washer and re-try..although lately it stops on a consistent basis. I have ensured the Filter is clean and also have removed the center basin in the washer and ensured that all is clear there also...however the problem still persists. What do you recommend... Thanks in advance for any advice. Peter.
The problem here is being caused by Blocked Filters in the Water suppoly In line/pipe. There are two(2) filters in this line, at the water connection point and at the Washer connect point(one at each end). If these filters become blocked, then the result will be a restricted water In-Flow and hence the Rinse & Hold Status. Disconnect the Water-Supply pipe and remove the plastic filters giving them a thorough cleaning before replacing them. All will be rectified by this action. Peter...
580 views
Usually answered in minutes!
i have a zanussi ZDT6252 i put it on a wash cycle during the night next morning risr hold was flashing, no cleaning was don.
i have check the filters both are clean, is their a reset function
×