E2 error in smeg dishwasher

SMEG DISHWASHER ERROR CODE E2? - How To Mend It

howtomendit.com > Kitchen Appliances, Electric Kettles
Free repair help - smeg dishwasher error code e2. ... Q & As - mend, repair, fix kitchen appliances, electric kettles, kettles, water, not, plug ... Search for - error, e2 ...

What do you mean "gas fault e2"? Your dishwasher is powered by electricity; not gas. Or maybe you meant to type "has fault e2" - well, now, that's quite a different story. Still we would need to know the model number of your dishwasher to be able to look up what that error code means.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

You may have to give a little more information.
Have a look at the manual, here -
http://www.manualslib.com/manual/343502/Smeg-Di612ca.html
and check for error codes/lights etc (p17; faults E1-E9)
Hope this helps

I HAVE A SMEG DW167.1 AND IT COMES UP WITH A E9 FAULT, DOES ANYONE KNOW WHAT I CAN DO TO SOLVE THE PROBLEM ,THANKS

Cleaning the tray and float resolved the E9 error on my Smeg dishwasher. Thanks!!

Hi.

E2 is called water safety level error. Unfortunately the problem is often caused by either a defective pressure switch or by a defective control board. The problem is quite common in SMEG built dishwashers like your Candy.

All you can do is disconnecting power for a couple of minutes, by either tripping circuit breaker or disconnecting power cord. That will reset control module. While power is off remove water (if any) from the bottom of the appliance.

If that does not do the job the parts must be tested and the appliance must be repaired replacing defective part.

Regards.

Ginko

E2 shows that the water level switch has been tripped or its faulty,interupt the programm and switch off the dishwasher then switch it on ,programm it again and start the washing cycle again,if the problem persist then test the water level switch for possible replacement

I don't mean to make you sound stupid but it isnt a switch that you can use.

It is used in a dishwaher to make sure that the water doesnt over fill and spill over out of the dishwasher and electricute someone. it cuts off the water (when working corectly) and washes as normal or if it over fills it tells you and in your case it is error E2

you need to speak to a appliance repare shop to see what needs to be fixed or replaced.
Hopefully this has givin you some help

if you have any questions plese dont hesitate to ask

your english sounds fine to me - far better than my bulgarian!
literally - in the front of the machine down at the bottom there is a panel about 10 cm high which can be unscrewed to give access to the base of the machine

tresilla

http://ukwhitegoods.co.uk/modules.php?name=Reviews&rop=showcontent&id=20

Under installation it mentions this problem

http://www.smeg-service.co.uk/support/index.php?a=1&cat=4#5

list of error code explanations