Error code c-c 152 - Konica Minolta bizhub 250 All-In-One Laser Printer

There is no Error code 152 listed
https://www.pridemobility.com/pdf/owners_manuals/operation_instructions/fault_list-q-logic-3.pdf

Nothing in the manuals

https://www.quantumrehab.com/pdf/owners-manuals/us_uk_au_q6_edge_3_stretto_om.pdf

https://www.quantumrehab.com/pdf/owners-manuals/us_q6_series_(q6_edge_hd_q6_ultra)_om.pdf

Videos that may help

https://www.google.com/search?q=quantum+q6+edge+3+won%27t+tilt

..

SC 544
Heating roller thermopile (center) error 3 The thermopile detected a temperature over 260?C. • TRIAC short, AC drive board defective • Defective IOB 2 • Defective BCU
Related SC code: SC 553, SC563 1. Do SP5810 to cancel the SC fusing code. 2. Replace the AC drive board. 3. Replace the IOB 2. 4. Replace the BCU.
GO TO SERVICE MODE AND SP5810 to Clear - Check temp inputs - SP5803 150, 151, 152

replace the developer and drum , clear counter and run F8

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Error codes to many popular brand TVs are given.

Download the CS3000 Series Scanner Product Reference Guide from the Motorola Solutions Support portal and scan the barcodes:

<Data> <Suffix 1> Adobe page 69 of 152
Scan Suffix 1 Adobe page 68 of 152
7 from the Numeric barcodes Adobe page 121 of 152
0 from the Numeric barcodes Adobe page 120 of 152
0 from the Numeric barcodes Adobe page 120 of 152
9 from the Numeric barcodes Adobe page 121 of 152
Save Configuration Adobe page 72 of 152

https://atgsupportcentral.motorolasolutions.com/content/emb/docs/manuals/13608804a.pdf

did you replace the developer also did you clear the counters first did you run the F8

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Code C-0510 means a low fuser temperature.

This can happen after a long copy job has been run.

To clear the code:

Power machine off

Turn on the machine with the stop key held down.

Turn off, then on again.

The code should be gone.

Dear Sheila

After connecting it to the motherboard, switch on the pc, then go to properties of "my computer" then choose "Hardware" then choose device manager and over here u will come to know weather ur CD rom has been detected or not, if it has a question mark then it means u have to install drivers for it, but if ur using Win XP, i am sure it shd detect automatically and need not ask for drivers. Hoping a good rating from u....!!!

Thankyou

POWER supply failed or FAN failure 888-103-409-094