No connection with wireless router

Hi, according to the manufacturer information this router does not have a WiFi functionality

Dynex 4 Port Ethernet Broadband Router

go to google.com and type bell: type the model of your router you can read the details of it.

You can go here and download the quick setup guide and manual for your router http://www.dynexproducts.com/products/computers/DX-E402.html which will walk you through the setup.

The most common reason it won't connect is that you must have the router's IP number (the one listed as default IP in the manual) set as the GATEWAY address on your computer network settings and your xbox settings, otherwise they can not talk to the router.

You should be able to do it from whatever computer you first set it up with under its settings.

You can confiure your without disk too .
Connect your router to computer with ethernet cable then you can access it with following default link.
http://192.168.0.1
or
http://192.168.1.1
If you are not able to access it with above ip then check your computers ip address gateway ip is your router ip try with it.
Then it ask for user name and password.
Type user as "admin" and password as "admin" or "password" or blank.
Then you can see configuration page of router.
Click on WAN settings and set those settings as your internet service provider settings.
Enable DHCP if you want to get ip from router.
Click on wireless settings enable wireless then enable WEP Security then add WEP code .It is your password to connect wi fi.Then save settings and restart router.
Then you can connect your wi fi network with that code.

Let me know if you need further assistance.
Thanks for using FixYa.

I'm not familiar with that particular router, but all of them are about the same. You can go in and edit firewall settings to allow a particular IP address to have access. Don't disable the firewall completely, just set it to allow that I.P address to have full access.

Download the user guide and follow the steps on page 13:

http://www.dynexsupport.com/sites/dynex/dl/DX-WEGRTR_07-366_Final%20CD.pdf

Here is the support page:
http://www.dynexsupport.com/product/?pid=DX-WEGRTR

Click on this link or copy and paste the complete link into your browser.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Unfortunately, the DX-E402 is not a wireless router, so it can not transmit its signal without a physical cable connecting the router to your computer. If you want a wireless router that can also connect to your ISP, check out the Dynex Enhanced Wireless G Router:

http://www.dynexsupport.com/product/?pid=DX-WEGRTR

You can download the software from here:
http://www.dynexsupport.com/product/?pid=DX-WEGRTR

When the installation software asked me if I performed the steps in the Quick Installation Guide, I just said yes. Here's what I had done prior (I'm not saying this is what the guide says to do, but, I was able to set up my DYNEX Wireless Enhanced G Router after having done these steps):

1. Connected the power cable and plugged it in to the wall.
2. Connected the Internet cable from my DSL modem to the Green port on the back of the router.
3. Connected my PC using an RJ-45 cable to one of the blue ports on the back of the router.