NO SOUND I HAVE EVERYTHING HOOKED UP AND IM NOT GETTING ANY SOUND.THERE ARE NO PROTECTION LIGHTS ON AND EVERYTHING APEARS TO BE IN WORKING CONDITION

It sounds like a cooling fan has stopped

It is hard to say what the problem could be. A lot of boards on this unit can cause the same condition. Lets start out simple. Can you get the menu to pull up? If you can then check your connections at your inputs and at the components that you have hooked up to the TV. If you can't bring up the menu, then I would suggest having a servicer look at it. You could have a bad tuner causing this, a bad digital board, bad analog board or even a bad light engine. To many variables.

Did your previously had it hooked up through hdmi????? Are you getting sound????? Try with the standby light on pushing in the power button and holding it until you hear a beep or two then let go....wait a few 10-15 seconds and see what happens....

try a radio shack mini amp sa-155 for around 30.00.

YEA CHECK THE OHMS ON THE SUB TO MAKE SURE THEY MATCH UP TO THE AMP JUS SOUNDS LIKE THE WIRING IS OUT OF PHASE.

Check speaker connections and wires and make sure all wires are plugged properly. If problem still exist then unplug speaker one=by-one and test home theater to determine what speaker is causing Protect error.

take the amp out and hookit up to the car battery and let it charge then unplug it do this a couple of times then rehook it to the cars audio system it sounds like your amp may be locked..

also check your speaker wires from amp to speaker box then from the back of the box to the speaker inside the box you may have a short..

thats where i would start.. hope this helps

Generally, if a Kicker amp has the power light lit and the protection light isn't lit, it's working. Are you sure that you have signal feeding the amp?

Are you sure your speakers are OK?

Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Vibe is mediocre. Time to invest in an old school Lanzar Opti Drive amp. .A thumbs up would be greatly appreciated if this answer is helpful to you.

It sounds like the output transistors have failed. Disconnect everything from the amp except for the B+, ground and remote and turn the amp on. If it goes into protect, the amp is in need of repair. If you want to repair it yourself, email power acoustic for the schematic.