Where is the overload reset button on hotpoint wd420

http://laundry.manualsonline.com/manuals/mfg/hotpoint/wd420.html?idRes=599706 here is a link to your manual hope this helps.

it is located at the back of the machine...are you encountering problems with this machine? check this link i will give you, this a forum/comments which the owners encountered different problems with this machine..

http://www.unbeatable.co.uk/p_rupr/Hotpoint-Aquarius-WD420-Front-Load-All-in-One-Washer--Dryer-Reviews/22394331.html

**** the red wire n tape it to thw white one

this usually means that the main pcb has a corrupted eprom or eprom memory has been wiped... you either need a new pcb with eprom or a new board pre-programmed.

hotpoints terms for error

Setup error: check eeprom
F09
Flash
OFF
OFF
Flash
OFF

You must check for overload try to messure the amount of clothing you adding to the machine, and try to restart by unploging the aparat from the wall outlet, wireing diagram are located usualy on the back of the aparat.

press and hold the start/reset button until all lights come on about 20 secs

Hi,
This link should get you what you're looking for:

http://laundry.manualsonline.com/manuals/mfg/hotpoint/wd420.html

Hope it helps...

You have a fault on the machine which is a dead short or an earth leakage.

Neither can be sorted out without a set of testers and some knowledge

Unless you can get hold of a resistance checker and know how to use it call a in a repair person

Yes I have the same problem but the Drying High Heat is also flashing

Flushing all button something wrong inside the machine ./The mahcine while flushing unplug it , wait for 30 minutes , Plug again observe ?/if still flushing the motor stuck/ if stop flushing the machine reseting.