Bosch dishwasher not taking in water

Domestic dishwashers work by taking cold water and soaking the dishes as the water warms. Then it gives a good wash at high pressure, drains, refills, rinses and then hot rinses to dry.

If it is slow because of slow filling, check the water pressure and also clean the strainer filters on the supply hoses where they go into the machine.

If you want speed, buy a small under-counter commercial machine. They fill with hot water, have a tank heater and a rinse tank heater and the whole cycle is 3 1/2 minutes. Glasses first, plates and cutlery next, and pots and pans last.

Seems to be a known issue!! Videos here with solutions

https://www.google.com/search?q=Bosch+Dishwasher+SHE43C+cycle+takes+too+long

..

Check water supply to dishwasher. If ok then check water inlet filter for block. If blocked clean or replace.

Hi!

Here you can find manuals for a huge range of Bosch dishwashers.

Hope you'll find here your device or a similar device which help you.


https://manualsbrain.com/en/brands/bosch/dishwashers

Hi Gilgol, The link below is a Bosh Dishwasher list of error codes, I believe your error code is E3....CHEERS..
http://removeandreplace.com/2015/10/09/bosch-dishwasher-error-codes-how-to-clear-what-to-check/
Bosch Dishwasher Error Code E3
Fault Condition: Not filling with water
Repair or Check: If the water supply cut-off valve on the dishwasher is completely open but the dishwasher will not fill with water then shut off the water supply and unplug the dishwasher. Remove the water fill line and check to see if the water inlet screen valve is plugged up. If so then replace the water valve. Cleaning the screen can make the issue worse so always replace if the screen is clogged. The valve can get stuck open from gunk and therefore flood or overfill.
Parts Required: Water inlet valve
Bosch Water Inlet Valve Assembly for Dishwasher

this sounds like flow sensor failure,it it fails machine will either not fill up or fill and drain without washing its a cheap part to replace and is fitted downstream of inlet valve behind l/h/s side panel either attached to inle hose or heat exchanger.

Sounds like the water pump has failed.

it is probably going to be a grimy door thermostat between the inner and outer panel. its hooked into the back of the soap dispenser. someone would have to take the outer panel off then clean wipe away the caked grime from the thermostat and put it back in its place. if this doesnt fix it then it could be a heat assembly problem or timer problem. in that case you would need an appliance tech out

was the safty tab on the inside of the units water receiver removed?

yes u got water on the bottom and there is a switch there first take the water from the bootom

make certain that there is water coming into the d/w if so and you are sure that the solenoid on the water valve energizes then its possible that the strainer on the water valve might be clogged if so its going to take a bit of work to remove and clean the strainer and reasemble it are you confident .