My healthrider c860e won't turn off. what do I do?

More than likely your going to need a console...If you checked all the power from the console down to the resistance motor and that's good then console is bad.

please test the battery by new ones, clean the contacts batteries and replace . test the reed switch see the diagram attached. However you must download from www. fitness.manualsonline.com

God bless you

The distributor is a high failure rate item on Hondas if I had to guess I would guess the distributor is the culprit. good luck.

The voltmeter should only go as high as 14-15 volts when the engine is running. I would check for a poor connection between the battery and starter.

Dear Sir:

1) Replace by good batteries new one 2) Clean very well the contact with contact cleaner spray from R.Shack.

2) Turn the flywheel untill passing for the reed switch,and adjust it see the diagram attached, and ready.
sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a

Removethe bolts or screws securing the console to the upright assembly. Lift theconsole and confirm that the cable connections are secure. Remove the coverfrom the console's battery bay and install a fresh set of batteries. Replacethe battery cover.2
Detachthe ends of the pedals from the crank axles. Remove the left and right discshields and side shields. Inspect the interior of the base unit and locate theflywheel.3
Inspectthe flywheel as it turns. Locate the magnet installed on the flywheel. Turn theflywheel until the magnet passes in front of the nearby reed switch. Loosen thescrew securing the switch in place. Rotate the switch to reduce the gap betweenit and the magnet. Tighten the screw.4
Replacethe left and right disc shields and side shields. Reattach the ends of the pedalsto the crank axles.
ernesto cuadramanagua, nicaragua

Check the battery and or power cord for the proper voltage.

Video about How to Test Battery

Check the fuses under the lower hood. One should be a 10 amp fues, the other should be 15 amp fuse.

Replace them if blown. If they should blow again, move the treadmil to an outlet closer to the fuse box/breaker box of the house. the house wiring where you have the treadmill may not be adequate for the treadmill.

HI,
If you can then before replacing the Motor control board do one thing. Replace the IGBT on the control board. Igbt is the component which drive the motor. It will not cost a lot. The only thing is you should be very careful while working on the motor control board because there you can see two capacitors which is capable of store charge for a long period of time even the treadmill is unplugged. Before doing work on the control board you have to discharge the capacitor. If not it will lead to serious electric shock. You will get many pages on web to know how to discharge an electrolytic capacitor. I have add the picture of the motor control board with the igbt marked. You can find the part number written in its frond side. Replace the IGBT first.



Ajin

baterr ywas dead changed it-new battery worked-discharged once air turned on-put in 2nd bateer yseems fimne as long as you don't turn on the air-if you do there is a clicking inside radioconsole and discharges battery