Minolta DI 183 error code FFC03

Recommend you replace the drum and developer, after clearing the counters for them. Then then run the F8 procedure

replace the developer and drum , clear counter and run F8

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

As I said before, Open the front door upper left is small access cover remove and depress the trouble reset. if the code comes back replace the scanner lamp and board.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Sir/Mam the you have the problem under the Di183 but you have di552 check the 183 no such code Sure it is a Di 552 and code is c145E?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Minolta Di 750 error code SC-23-01 i want solutions this code.

Konica Minolta MINOLTA BRAND DIALTA... - Fixya

www.fixya.com/.../p4705803-konica_minolta_minolta_brand_dialta_89...

Konica Minolta MINOLTA BRAND DIALTA 8935-902 BLACK TONER TYPE 603AFOR USE IN MINOLTA DI-520 / MPN:8935902 SKU:1745166 - Recent Questions, Troubleshooting & Support. Recent; Popular · Answered ... Error code c0-f24.

Code c0510 in dialta 520 how to reset - Fixya

www.fixya.com/support/t16313340-code_c0510_in_dialta_520_reset

Feb 2, 2013 - Code c0510 in dialta 520 how to reset - Konica Minolta MINOLTA ...Home · Forum · Fax Machines · Konica Minolta · MINOLTA BRAND DIALTA 8935-902 BLACK TONER TYPE 603A FOR USE. ... BLACK TONER TYPE 603A FOR USE INMINOLTA DI-520 ... My minolta dialta copier has a c-of24 error code,.

C-0600 there is a code shown in my di520C-0600 tell me ...

www.fixya.com/support/t16673596-c_0600

Well need to replace the drum and developer running F8 with out changing the developer is not good, also make sure you clear the counter before replacing the drum and developer done toghter

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Abnormally high toner density detected Black ATDC (auto toner density control circuit)

Replace black IU, check toner motors, make sure toner is loose not clumpy. Change dev reset toner level.

Thanks.

good luck!

CAUSE: Adjustment mode 11 is not set to correct value.

SOLUTION: To set Adjustment mode 11 to proper value, perform the following:
1. Enter Tech Rep mode (Counter, Stop, 0, 0, Stop, 0, 1).
2. Press Stop and then Start. AJ- will display.
3. Enter 11 from the keypad.
4. Press Start. Current value will display.
5. Press Clear.
6. Enter a value of 1 from the keypad.
7. Press Start to save the setting.
8. Press Auto Reset to exit Adjustment Mode.
HOPE THAT HELP