Changing the code on standleford es20 safe

There should be a manual key override just for situations
like this.

i forgot my combination to my 15115 sandleford safe how do i open it

How to change battery on sandleford ES20

i was told u can call company with proof of purches and they can give a over ride code

I have a new N15115,ES20 electronic safe,it will not accept a change of password.when new password entered it only beeps once ???

I have locked my safe I think by entering the wrong code. can you please advise how I can set a new code.... I cannot find the book that came with the safe.... thanks

lost key know code cannot open

Local service centres or supplier can usually reset the electronic key for you by overriding the system lock by keying in a certain service code. However, this depends on the capabilities of the specific model. Please find the local service centre for your brand of safe and talk to them.

The operating instructions on the ES20 as per the crappy manual:

Open safe using emergency key provided

Insert batteries in the box inside the door

Opening the safe
a. pre-set factory code 159
b. input 159 (the yellow light will flash and the buzzer will beep), then press B or A button, the green light will be on, rotate the knob clockwise, pull outwards, the door is opened

Closing the safe: close the door, input the code (the green light will flash for 5 secs). Turn the knob anti clockwise, the control system will activate and the safe will be locked

Changing the code: open the safe, press the red button located inside the door, the yellow light will go on indicating the code can be changed. Input the new code (1-8 digits), then press A or B button, it shall be confirmed by two beeps indicating the new code has been accepted and stored. If the yellow light and buzzer beeps 3 times the code is invalid - try again

Emergency Key - store in secure place NOT inside the safe. Remove the override cover in the centre of the face of Safe (its a silver plastic panel with Sandleford Electronic Safe ES20 on it), insert override key (a cyclinder key) - hidden underneath the override cover panel - and turn anti clockwise, rotate the knob clockwise to open door

Changing the Battery - If the red and green light are on this indicates that the batteries are low and require changing. To ensure the batteries have been installed correctly test before closing the door

References:
1. Operating instructions EA Electronic Safe
2. http://www.secustar.com/products-en/estype-safe.htm

have just had the same problems if you had the key there is a red button inside the door to reset the code but obviously no key no red button I have the sandleford number to call 03 97750699 or try the factory pre set 159 A or B see how you go