Showing fault 49 what is it
SOURCE: WASHING MACHINE WONT START UP AND DISPLAY FAULT
Fault 49 indicates Out of Balance fault- usually faulty microswitch. To access- disconnect from power, remove two screws at top rear to remove control panel. You will see large brown control board. Disconnect all wiring connections, taking note where they came from (they are keyed to only fit in correct slots, but is best to note positions anyway). Remove brown control board (held in by either one screw, or clip on right hand side) Underneath control board you will see a small microswitch with two wires on it- this is the Out of balance microswitch. Often the switch will be corroded, or the little button is stuck in. Replace microswitch- they are available from any good appliance parts shop, and you'll be back in business!! If in any doubt as to doing this yourself, call in the experts, as it is an easy repair for a tech, and you don't want to make an easy repair turn into something more expensive!!
SOURCE: washing machine fault
Kenmore Elite, spin cycle will not wring out the clothes because the tub is not spinning, you can hear it working though. Please show a diagram. Thank you.
SOURCE: hotpoint ultima super silent w f 840 shows fault 03
Code f03 means wash thermistor open circuit, this is normally part of the heating circuit, suggest you test heater and thermistos located in the end of the heater, and replace if necesscary. If heater o/k , then could be bad connection to control module, or broken wire, if still no joy, then call Hotpoint.
Please rate my solution.
Thanks.
SOURCE: Fisher and Paykel Intuitive Eco Washing Machine
The drain pump is overheating. I suggest you do not try to use the machine until you replace the pump unit, failure to stop using the machine will result in the pump short circuiting and destroying the main control board!. Please go buy a new pump and fit it.
SOURCE: hotpoint ultima washing machine is showing a fault
F 05 normally means there is a blockage or a fault with the pressure sensor. The common place for blockage is in the black pipe from the drum to the pump as it has a filter in here and clogs up. remove the pipe and clean the filter out and remove gunk from the pressure sensor on the side of the pipe as well. If that does not fix things the pressure switch could be faulty itself
197 views
Usually answered in minutes!
My machine justs beep when i turn on and displays fault 49 its aaqua smart from fisher & Paykel any one know how to fix it
×