Installed a new refilled PG-5BK ink cartridge into an MP530 printer and get the error message 1681.

I assume you have a Canon copier based on the E007 error code. The Fuser fixing film is torn and the Fixing film assembly or the entire fuser should be replaced. Very common issue.......You cannot reset that code without first replacing the part causing the code.

CHECK INK
A.
U130

An ink tank that was once empty is installed.
Replace the ink tank.
Printing under the situation may damage the Print Head.
Canon shall not be liable for any machine malfunction or damage caused
by refilled ink tanks.
If you want to continue printing with the refilled ink tank installed, press
and hold the [Stop/Reset] for at least 5 seconds, and then release it. Using
refilled ink tanks are memorized.
* This operation will release the function for detecting the remaining ink
level

B.
i am not sure but is working on 520
1. print mono or print color for color
2.stop
3.ok
4.on/off

1. Switch the printer OFF
2. Press buttons 1 + 2 + 3 and 4 (simultaneously using four fingers)
3. Keep pressing this four buttons for 10 seconds
4. Release the On/Off button (number 4) (Keeping pressing the others)
5. After a few seconds (when the printer go ON) you can release buttons 1, 2, 3

1. Maybe step "c)" is not needed
2. This procedure was used when I refilled the Black cartridge - try using the ColorCopy button instead of BlackCopy button (number 1) if you refill Color cartridge.
3. Maybe there is no need for all the four buttons - you can try 1 + 4, 2 + 4 or 3 + 4. (or 1+2+4, 1+3+4, 2+3+4)

I have Canon M560 printer installed 8 months ago. I replaced the CLI 221 Magenta and CLI221 Cyan ink cartridges, won't work and got this message Error 1411. Tried repeatedly to reinstall the ink cartridges and still have this message coming back. Any solution you could offer? I would appreciate it. Thank you.
ben

Dear all,
To fix this problem, first check which ink blinks, then replace it with new one. If this does not fix your problem, here are possibilities: carriage part error, logic board error. Be careful of short circuitry problem in this case. It may harm other electrical part

Regards,

Related Topic at:
Canon Inkjet Printer Forum

I think one of your cartridges is pretending to be a black cartridge. Are they refilled carts?

I have the same issue as well - I just open the printer, pop out the cyan cartridge, and reinsert it (the same one). This generally works - sometimes I need to do it once or twice. I figure I'll be patient and keep doing this until I a) finish the cyan ink cartridge, b) replace it out of annoyance, or c) through the printer out the window in total frustration.

Interesting to hear about "faulty" cartridges though - I shell out for the "authentic" Canon cartridges which you would think would be reliable - maybe I should switch to using the imitation ones if I'm going to have issues with them anyway...?

replace with a original cannon new cartridge and try again

Install recommended ink tanks in the correct order MP500 / MP530 / MP800 / MP800R / MP830

Ink Tank Order Install ink tanks in the correct order (from left to right) CLI-8BK (Black) PG-5BK (Pigment Black) CLI-8Y (Yellow) CLI-8M (Magenta) CLI-8C (Cyan)

There are possibilities that you might not have installed the ink cartridges properly or the drivers might not be working.

Here is a link for a manual click here
Here is a link for drivers click here

Your printer drivers may not be installed properly

Here is a link for
Manual click here
drivers click here