Machine wont stop filling with water, it just overflows. Machine is an Asko w6551 front loader

inlet valves are out of service or malfunctionnign follow the steps .

1. unplug your machine power cord.
2. open the door and also open water supply , if your machine fills the water then 100 % problem is with your inlet valves , replace it , simple

regards

try here..............

http://laundry.manualsonline.com/manuals/mfg/asko/wl6511xxl.html


cheers

d3122 Asko Dishwasher fault code F2 - how do you stop pump runing and reset?

you need to remove the drum start at the front remove front panel,four screws 2 under front,1 behind soap drawer and the one near the filter,next take door off 4 spring clips on the next panel plus screw on door lock,remove door lock,then undo clamp band,bolt at bottom and remove counter weight panel (heavy).remove stainless steel inner panel,use a screwdriver to loosen,from the back remove drum pulley.the drum will then pull out.replace vseal and bearings.hope this helps

the pc board is bad must replace.

MAY BE THE WATER SENSOR IS BROKEN,THE PCB FAIL TO GET THE SIGNAL FROM THE TUB FOR THE WATER LEVEL

Check the drain line to make sure the water does not siphon out as it enters the machine.

Replace the water valve and your problem is gone.

you need a new inlet valve take off the top panel then you see the inlet valve follow the inlet hose

When u use front loaders you normally don't need a soak. And i don't think you need bleach. Use front loading powders for the machine. The automatic machine is supposed to work for you. The water empties out, so you can open the door.

Rate me pl if helped..............