Need info or a manual

Hello, Ticle33 did you ever get he hold of a wiring diagram for the si-tex profish II? I am in the same situation and cannot find one. Hope to hear from you. Thanks /Tom

Hi!

No problem. Here's the link to your manual!

http://www.manualnguide.com/dl/15864/

Happy Boating!

I NEED A TRANSDUCER FOR AN EAGLE-168.
SOMEONE CONTACT ME. PLEASE..............

[email protected]

with the correct transducer you can mark fish at 600 and bottom at 100 feet

Hello,
Try to check from this link out:
http://www.si-tex.com/2009support.htm
There are manuals for GPS devices listed there.
Goodluck.

hi guys i need the manual guide for cvs-106mk2 in greek version....

http://www.si-tex.com/html/support.html

E-mail them at [email protected] with your request and they will e-mail the manual to you.

Hello LJones0455. From your detailed attempts there are few options. Position the transducers one foward one aft. Connect the negitives of the battiers to the boat still route both positive & negitive wiring to all devices. Check the continunity of your transducers include flexing while ohming. Let me know of the results.

To re-program the Si-tex CSV-106 depth sounder to feet/meters/fathoms: Push and hold down the MENU key while turning the unit on (POWER key) to enter a special menu. Release both keys after you hear two beeps, almost immediately. Use the LOWER ALARM key to select the desired unit for depth, then turn off the depth sounder. That's it, just turn on again to see the change.
There is also another menu (for testing sounder) available by pressing the MODE and turning on as above.

Yes, they are. Call SITEX 727-576-5995 x139