Connecting my iPod to the HTR-7450 receiver

Willard, Check the attached links,reset receiver.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Yamaha HTR 6060 Owner Manual Resetting The System

Yamaha HTR 6060 MCXSP10 Manual Page 94

Yamaha HTR 6060 Manual Page 104

Yamaha HTR 6060 Manuals Support and Troubleshooting Receivers

Your remote ID number is - RAV 250 Your remote part number is - WC552800 Cost - $32.95usd
And you can get the exact same one here http://www.yamaha.newremotecontrol.com/catalog_item.php?catnum=WC552800
Hope this helps
Regards, Tony

Yes - just go to electronics store and buy a 3.5 to 2 RCA lead and plug the 3.5 plug into your IPOD and the RCA plugs into the Aux sockets on your Yamaha. Job done

Get a 1/8" miniplug-to-RCA-cable adapter and plug the headphone output directly into any compatible input on the receiver. Press PLAY.

Read the article (it's short). Don't buy into the hype about better cables. IPOD's don't stack up as hi-fi to begin with and cables are cables are cables....

http://www.dummies.com/how-to/content/connecting-your-ipod-to-a-home-stereo.html

Hi, I'm afraid that your receiver doesn't support YDS-11. You can check it at yamaha site. This dock uses special cable and special connector on the receiver (which yours doesn't have).
So the only way to connect your iPod to receiver is via analog audio output (jack connector on the iPod).

Yamaha does make a docking station for the iPod but your receiver doesn't have the input for it. You can use this cable, http://www.buy.com/retail/product.asp?sku=208112882&listingid=57249305 and connect the cables to the back of the receiver. To set up the iPod tv out settings go here http://macdevcenter.com/pub/a/mac/2005/11/18/video-ipod.html . Good luck!

try use 1/4" stereo plug to two RCA plugs used with amplifiers and mixers
[img]http://www.mcmelectronics.com/images/product/icons/magnifier250.gif[/img]
use yamaha cd or aux input ..

i know this sounds stupid, but have you "toggled" or "played" with the HDMI cables? are they the same manufacturer? HDMI channel connections are very fickle. If just one connection is not exactly correct, they go to a limp, no go status. Since they run at such a minimal voltage, i can't see them "blowing" the outputs on the devices.however....if your cable has a serial type output for video only, I would connect the hdmi convertor to it and see if it works.

If it doesn't have a jack made for plugging Mp3 players into it like the new car stereo's do than you just have to go buy an FM transmitter that is made for Mp3 players. It will play through one of your low FM frequency's on your receiver. You can generally pick one up for around $20

Hi,


Yes, you would need an iPod to RCA Cable that will connect to your iPod and to the RCA Auxilliary input of the Yamaha HTR-5790 7.1 Channels Receiver. Similar to a Cygnett Groove Transit - MP3 Phone to RCA Stereo Cable or an iPod to RCA Retractable Cable.


Good luck and kind regards.