What kind part i need to chang? when i get problem code f1?

F1 error means there is a problem with the key panel and the key panel needs to be replaced. That kind of explains why you got the error when it was not in use.

What kind of detergent are you using? F1 in most cases means that the wrong type of detergent is being used. If it's a front-loader, you should be using h3 detergent.

F1 code means a shorted keypad. Replace the membrane or control, depending how it's available

Hi,

"F1" code clearly indicates that main control board has failed. The possible fix for this kind of problem is you have to replace the faulty circuit board. This is the only solution and you cant repair anything else in this unit when F1 flashes.
Thank you !!

JENN-AIR
'Newer Style' Range/Stove/Oven Fault Codes Failure
Code Condition Check/Repair F1 Power to element relay energized during time of day display Wiring harness shorted or change power relay board (PRB)

Note: for double ovens, change second oven board

JENN AIR
Range/Stove/Oven Fault Codes Failure
Code Condition Check/Repair F1 Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)

F1 means communication error, Unplug washer for 2 mins.. What might have caused this problem is a power glitch of some kind.

F1 E1, replace Electronic Range Control.

In other words, the controller board has failed.

Hello welcome to fixya,


Below I pasted the fault codes for the two different years of this range.

To diagnose these difference you will need a hands on tech !
this is not an easy thing to determine

JENN AIR
Range/Stove/Oven Fault Codes
Failure
Code Condition Check/Repair F1 Defective touch pad or membrane Replace touch pad or membrane (this problem is usually the touch pad)

JENN-AIR
'Newer Style' Range/Stove/Oven Fault Codes

Failure
Code Condition Check/Repair F1 Power to element relay energized during time of day display Wiring harness shorted or change power relay board (PRB)

Note: for double ovens, change second oven board

Hi,

To my understanding error code F1 would indicate a faulty control board, possibly thermistor control. The only recourse is to have this replaced.

This of course would require a fair familiarity of electrical/electronic components/circuitry and safety procedures, use of a DVM and possibly a soldering iron. It would be to your added advantage access to a service manual or at the very least a schematic diagram with voltage readings. Should you be uncomfortable performing a DIY (do-it-yourself), perhaps your best bet would then be to seek the services of a qualified professional.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Have you tried changing the cmos battery on the motherboard?