Set time on python 951 - 991 Responder LC3 SST Security/Remote Start System

http://www.directeddealers.com/manuals/IG/Python/N5904%202011-09b%20web.pdf

It sounds like the factory alarm is setting up. To make sure the factory alarm does not come on you should make sure all doors are closed before you actually hit the remote to lock the doors. Do not lock the doors with the switch on the door. Make sure you use the Python remote only and all doors closed before you press the lock button.

The plug of the remote is similiar to many cell phone chargers. They can also be charged with a USB cable connected to a computer.

I assume that you do not have a manual for your watch, so you can get one by going to their web site http://www.lacrossetechnology.com/support/manuals.php and choose the manual for your watch.

unlock car via remote Push and hold F button for about 8 seconds until it says setup remote on the screen Use the aux and remote start buttons to scroll to CLOCK and then use the F button to access menu.

usually a combination of 2 buttons so the car doesnt start accidentally.

Depending on the number of output channels - the installer could have installed on any of the channels and that would dictate which buttons to press.

if it is not set on the AUX (output 2) button, then try...

1. Lock + unlock at the same time - output 3
2. * + AUX at the same time - output 4
3. Lock + Aux at the same time - output 5
4. Lock + * at the same time - output 6

You have not given the model # of the unit - so these are viper's STANDARD remote controm configurations.

CLICK HERE to enter your correct model # and Download your instruction manual.

Hope this helps.

Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

The P stands for programming. It's used when setting up the alarm system, you would need the manual for the system to tell you what can be done. I have a Python 990 and I can change pretty much everything from sensor adjustments, amount of time it turns over for starting, disabling the siren and many other settings. I found out the hard way one time when I accidentally pressed it and turned the key off and it disabled the siren. I think that's how it happened, been a while since it happened. I would have to get the manual out to be exact. You can also do the programming by pressing all 4 buttons at once and hold for 2 seconds. But you still need the manual to know what your doing. Hope this helps