Need find a place that fix pioneer radios - Pioneer Audio Players & Recorders

Walmart and some auto parts stores have installation kits that have the plugs already wired for your radio and vehicle harness. You simply connect them together.....no cutting or splicing.

The back-light for the display has gone out from the sound of it. Contact Pioneer if it's still under warranty or find a place that fixes or could help you to fix the radio.

Bad TSOP flash chip. No way to fix without disassembling, removing the flash chip, and placing a new flash chip on it. Doing so requires a donor radio (with another issue), and will change your XM Radio ID. You'll also need to have a hot air (or IR) rework station for desoldering the old chip, and a soldering iron for placing the new chip on the radio.
I'd say give pioneer a call since it's a design flaw, and a VERY common issue. My best guess is that it's caused by excessive heat & defective chips.

the wires will not be the same. the best thing to do is go to the nearest place where they sell radios and they do have to sell the two plugs that have the same wiring diagram as the radio and then direct connect to the two plugs on the car.

Some places like Best Buy offer a disk that you put into the changer and it will reset the deck.

Just off the phone with Pioneer customer service. Apparently a "software glitch" common enough that an internal memo has gone out to replace units under warranty without further trouble shooting. The last step in the process was to remove the battery, place in the original charging cradle without the battery, and hold the power switch down for 10-15 seconds; if the "Please wait" message continues, the unit is defective.

yea, you need to purchase a separate "box" that pioneer requires for ipod operation. you can find it at best buy or ebay, places like that. just look up "ipod adapters for pioneer...

When its in the car dock, the Inno sends an FM signal to the car radio. It does not receive a signal from the car radio. You must have the external antenna correctly installed outside the vehicle for the Inno to work. The built in antenna is disabled when the device is placed in the car dock. Make sure to test it outside, since garages or car ports will block the signal.

ribbon gone, common problem cost £120 to fix (don't know why cos ribbon only cost £35), just got mine fixed

If it's been installed with the original DIN mount, there are 2 small flat clips that slide in a small slot on each side of the radio. The 2 pieces of metal are pushed in to release the clips holding the radio in the bracket. Then the radio pulls out

Those clips come with the Pioneer stereo but should be available from a place that sells/installs car audio