I am getting an error code F/H but it works most of the time. Then it just quits
Hello lilo1
Welcome
You said, You are getting an error code F/H but it works most of the time. Then it just quits
You may have low water pressure which the machine senses and after some minutes will shut down .
If any pump runs with insufficient water pressure it will burn out the pump so washers are made with auto shutoff's in those case it does shut off.
Check that the water valves are passing water out of the taps that are connected to the washer and they did not fail.
When you remove the water supply hose from the washer inlet, you will probably find the screens in the washer water inlet are blocked and need to be removed and cleaned off and then replaced.
Do not bend them up and you can re use them!
Below are causes and more remedies
Let me know how it goes!
Huuum
Please remember to leave a rating?
F/H Error code
No
water detected entering machine or Pressure switch trip
not detected.
If after 30 seconds the control does not detect water entering
machine and then valves will be turned off and the error
code will be displayed.
Or
If
the control has turned the water valves on and after 8 minutes
the flow meter has detected 10.5 gallons of water passing
through it, but has not detected the pressure switch trip,
the valves will be turned off and the error code will flash.
Check/Repair
Press
PAUSE/CANCEL twice to clear the display.
1. Make sure that both valves at the water source(s)
are turned on all the way.
2. Check for plugged or kinked inlet hoses or plugged
screens in the inlet valves
3. Verify inlet valve operation
1. Verify Drain pump operation
2. Pressure Switch Hose is in good condition and
properly connected to Tub and Pressure switch
133 views
Usually answered in minutes!
×