Beko Freestanding Dishwasher

Check water supply to dishwasher. If ok then check water inlet filter for block. If blocked clean or replace.

Assuming you can select programs and start it, the most likely problem is water inlet valve. Make sure the water tap under kitchen sink is open.

The water inlet valve looks like this.
Beko DS1054S Solenoid Valve

Is the water inlet turned off by chance? Is there no water at all inside the dishwasher?

I have just had this problem with my Beko dishwasher. Mine was running the pump constantly, I tried the tipping method which did reset a switch, and the machine would start to work properly then go back to just pumping again.
I tipped the machine up(lots of water came out) and took the bottom cover off which has a float and a switch in it. This switch stops the water flowing so not to flood your room when there is a leak within the machine. Now I had a good look around for split pipes etc and found that there was a pipe that had popped off completely, I put the pipe back on with a new clip and now it’s as good as new!

My BEKO dishwasher is turned off but there is a constant dribble of water running in to the machine. If I open the door when this has happened, it leaks water all over the floor. This means I have to keep turning the machine on to drain the water away.

Solved by draining water from bottom pan.

i think you are hearing the drain pump going. take the bottom front panel off so as to expose the bottom tray. yoy willprobably find this full of water. mop water out and it should work. if fault reoccurs then you have a leak.
turn power off first

possibly due to water in the sump tray. tilt machine back at 45deg and see if water runs out. if it does and you get rid of the water that way, then the machine should operate. if it reoccurs, then you have a leak

sounds like your machine is not taking in any water at all, which is the first thing the dishwasher wants to do on all programme settings.The constant whirring noise you refer to will be the water valve trying to take water into your machine.As yours isn't filling in the first place the programme cannot progress without water and it will just sit there whirring.Anyway, to resolve this matter I would check the fill hose which goes from the back of machine to your cold water pipe in your kitchen/utility, in case somebody has turned off supply.where the flexi hose meets the copper supply pipe there should be a thumbturn shut/open valve, turn this 90 degrees or a quarter turn and if you here a rush of water for a split second then you have fixed it.At this point try setting away a programme to see if water is going into dishwasher. If not have a bucket ready and unscrew the flexi hose altogether to make sure water is travelling past shut/open valve.If not you need a new shut/open valve.If water is able to pass this valve reconnect to dishwasher turn shut/open valve a quarter turn to open flow of water again,test machine on any programme again ,if it fills then your sorted, if not it must be your dishwashers internal water valve that will need replacing.Not a major job (located behind fill hose) but make sure electric and water supplies are off first before dabbling and write down your machines make and model number before shopping for part. GOOD LUCK.