Glo warm? i have a glo warm and have ran out of propane but have a 2o lbs tank,is there a problem with useing it,the pilot light keeps going out.

Nothing I read shows that it has a mains cord. It is a very basic wall heater, no lights, no electric ignition, and it has a pilot light and thermocouple.

https://www.google.com/search?q=glowarm+propane+heater+power+cord

https://www.google.com/search?q=glowarm+propane+heater

..

verify the inlet pressure to the heater. those pezioelectric spark lighters are garbage. make sure all manual shut off valves to the heater are open. Pilot tubing may also be blocked

The tank size dosn't matter all you need is a feed line This looks like a spicific tank appalaction but just feed it remotely with a normal propane tank and a feed line and save your self the head ache as long as it dose what you want it to do ist cool

Hello,
Ok, let's get the easy to check things out of the way first.

1) Is the tank empty? Take it out and weigh it on a bathroom scale. Most empty tanks weigh approx 18 lbs. The TW (tare weight) of your cylinder is stamped on the collar. If it weighs within a few lbs of your tare weight, then you simply need to refill it. Propane weighs 4.25 lbs/gal, so it would weigh approx 22 lbs with 1 gal of gas left.

2) Did you turn the tank valve on too fast? Close the tank valve, disconnect it and reconnect it. Then very slowly turn the tank valve back on. Try lighting the pilot and see if that helped. If not, try #3.

3) Your pilot orifice is dirty or has a spider web. Grab a can of compressed air (like you use to clean computer keyboards) and blow out the dust or web from the pilot assembly, which is where you light the pilot flame. Try lighting it and see if that solves it.

One of these 3 tricks should fix it. Douglas

There may be dust building up in the ODS safety pilot assembly. The simplest way toresolve this is to flish the pilot with rust buster. Why rustbuster? It has a telescoping tube that makes it easy to direct the squirt into the pilot. Let it dry then retry. You will be amazed.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

make sure you have the gas valve knob on turned to pilot while pressing that down while pushing the spark it should light or it is tripped on a safety like rollout switch or oxygen depletion sensor if equipped which all ventless heaters are

Pressure in your tank drops with cold; you may need to tent it and provide a moderate heat source to keep up the pressure. Just like tire pressure- drops when cold. Thanks, please leave feedback or contact me again for more info if you need it.

my heater says if the pilot light keeps going off automatically it is a safety function that means it does not have enough fresh air to operate

We had a problem keeping the pilot light to stay on, and this site recommended that it could possibly be the thermocoupler that was causing our problems also. We ordered the thermocouple, put it on,hooked it back up and it worked great! Thank you so much.
ordered thermocouple from www.masterparts.net