I have a jet 3 ultra worked perfict and then turned it on and the speed lights scroll across about 4 times then it turns offI have a jet 3 ultra worked perfict and then turned it on and the speed lights scroll across about 4 times then it turns off
AnonymousMar 29, 2014
Tried charging batteries cant get it to do anything. Chair hasnt been used in a couple of yearsTried charging batteries cant get it to do anything. Chair hasnt been used in a couple of years
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.pridemobility.com/...manuals/...jazzy/.../au_jazzy_1... Pride MobilityJAZZY 1122. How a Power Chair Should ... NOTE: This owner's manual is compiled from the latest specifications and product information available at the time of .
When the red light is on it is to indicate that the charger is getting power from the wall outlet. If there is a second light that normally comes on Green when charging pay close attention to it when you first plug the charger in. See if it blinks even once then turns off. If it does that means the charger is not seeing any battery voltage at the plug that goes into the chair. If the green light does not blink at all then it usually means the charger is defective. Also most wheelchair battery chargers will not charge the batteries if the chair is to dead to even turn on.
Two red lights blinking means the electronics on the chair think the batteries are low. Test the voltage on the holes marked 1 and 3. Hole 1 is positive and hole 3 is negative. Your meter must be set on DC volts and the meter leads must be in Common and Volts. If your meter has to have the voltage range set, put it on 200vdc. The red lights will blink if the voltage is approximately 22.5vdc or less. The green lights turn on about 24.5vdc or higher.
There are thermal fuse under the chair where the batteries are . This is to protect the motors from overheating and ruining them . The fuses are availible on ebay or any medical supply store that deals with wheel chair . I replaced the ones on my mother - in laws Chair and anyone who has a little mechanical ability can change them . They were $10 Each when I replaced hers last December . It is alot cheaper than the motors . That is why they are made that way . Good Luck !!!!!!!!!
Hope this helps!!!!!!!!!!!!!!!!!!!
The number of lights that are blinking indicate what the problem is.
Visit this site to locate the type on controller on your power chair and
you will be able to see that the blinking lights mean: http://www.pgdt.com/scenter/diagnostics/diagvsi.html
Try to reset your manual brake release as this is a common problem.
If you continue to have a problem, contact your manufacturer or dealer
for service. If your insurance purchased they power chair for you, they
may also cover the cost of repairs.
Good luck!
try pushing the chair. If the chair moves your motors are disengaged. to engage your motors look at the base of the chair there should be a lever possibly 2 push, pull or turn depending and try your chair again if you need additional help you can reach me at 404-966-3734 and i can walk you through it
I am going to try checking the main fuse in the front...
I have a jet 3 ultra worked perfict and then turned it on and the speed lights scroll across about 4 times then it turns off
Tried charging batteries cant get it to do anything. Chair hasnt been used in a couple of years
×