Older model Kenmore Electric Range - all burners stopped heating at about the same time. How to fix?
Have you checked your fuse box. The Electric Range is on a separate circuit. Check to see if it is tripped or off.
If it has tripped and you reset it, that usually means there is a problem with the electric range.
Let me know if that helps.
Testimonial: "This did not fix the problem but easily could have been the reason my burners wouldn't work. I appreciate the suggestion."
SOURCE: oven quit working
Hi. this is common in many old gas range ovens. There is a set of coils that are attached to the gas valve assembly. These coils , when activated and operational, open and close the main and secondary valves in this unit. They are controlled by the main ERC(clock/oven control board). I recommend checking these coils and there respective wiring harnesses. if the clips and wires are worn and corroded, simply replace the entire wire harness.
Now, if the wiring harness and wires that are connected to the coils look good and there are no signs of corrosion on the wires and connector clips, this will confirm that the coils have failed and you will need to replace them.
You can also preform an additional test with a multimeter. simply connect your multimeter or voltage meter to both terminal posts located on the coils. once your meter is connected, start the oven cycle. you should register some sort of current during this test at this time. if the current is sufficient and the coils do not initiated the valve action, this will confirm coil failure. if the meter dosen't register a current during oven operation, this will confirm ERC(control) failure. you will have to replace the Oven control board in this case.
The Most common issue in this situation will most defiantly be the coil assembly and not the control.
Please rate and god bless:)
SOURCE: Kenmore 790.9622 electric range - front right
You have to use a voltmeter to make sure the element is getting voltage, if it is, then replace the element
SOURCE: Kenmore range front left BIG burner will not work
Check infinite switch...110V one side 11ov other side
520 views
Usually answered in minutes!
Checked the fuse box...nothing was off but I did reset the marked Range. Tried the stove again but burners still don't work. The over DOES work though???
Opps...typing too fast...I reset the one marked 'Range'. Top burners still don't work. The oven DOES work though???
×