Model g1405z,,,120V-60Hz,,,,,1600 watts
This is the fourth Shark iron i have own,,,,and have had the same problem with all four,,,,
They short out at the cord inside of the swivel,,,,,This iron however sparked and burned,,,,,
I take in ironing,,,,so want a profesional iiron,,,,But there has to be a way almainate this problem,,,,
please respond, asap,,,,,,[email protected]
thank you,
Janet L. Broussard
I always purchase your Product and Irons. I like your product very much. so please provide me with address to sent this Iron back for repair. It has always made the lights in the room whenever I Iron go on and off. Also shuts off and on during ironing, then and water leaks from the iron. " Please Help"
Martin
My wife has the Shark X-tended Steam Burst Iron with the same shorting out in the power cord. A very easy repair of about 30 minutes.
Remove the 4 screws in the back cover plate.
Pry out the 2 rubber coated resting pads on the bottom of the cover plate to expose 2 additional screws.
The cover plate will lift off exposing the wiring and power cord
Remove 2 screws that attach the brace that pinches the cord to the iron frame.
Remove 2 screws that connect the power cord. (note which wire, ribbed or smooth, is attached to which screw.
Cut the power cord just above where the brace pinches the cord.
Crimp a connector to each wire and attach the power cord as it was before.
Attach the brace which supports the chord and then attach the 6 back cover plate screws.
Insert the resting pads back into the cover plate.
Your shorted out power cord should now be fixed and you just saved yourself $50 or $75 bucks.
What did you use to remove the screws from the back cover plate?
×
3,196 views
Usually answered in minutes!
The same thing happened to me, i dropped my iron and before it hit the floor i caught it by the cord, it started smoking and smelled like an electrical fire so i assume it shorted out.. i just wanted to make sure the company was aware of the problem but when i tried the SharkCo.com website I found that it is no longer available. back to Sunbeam for me
shark iron steam buttun stuck
×