MOTOR FOR PATTON FAN A040882411

Question edited for clarity.

This appears to be a Walmart, Amazon, eBay special without a maker website which usually means made in China and sold in bulk. There is limited help here and some videos. Motor and Capacitor wiring all works to the same diagram.

https://www.google.com/search?q=20+inch+patton+high+velocity+floor+fan+wiring+diagram

..

Best place usually is grangers if you just need a motor. Take in motor and they can match up the exactone for you.

Most have a one-time thermal fuse wired into the motor. You would have to remove cage and fan blade, unscrew motor mounts, open motor casing, locate fuse by cutting open or sliding off the thermal sleeves, cut fuse out and resolder a new thermal fuse in. Should be able to locate replacement thermal fuse online. Can also just splice ends together but then you lose thermal protection and a fire can result. It is a good temporary fix to diagnose if you have burnt out one of the motor coils.

CTG ' Order 1010MP from PATTON ELECTRIC CO INC Now from CTG !

It looks like you can purchase a motor here.
Make sure you have the correct data from your motor.
There is also a contact button so you can probably call, too.

Good Luck,
Your FixYa Texpert,
Gary

You can generally find new motors at an electric motor shop, check the yellow pages. However they are many times more money than a new fan. Then add time and your drive to get the motor, my recommendation is purchase a new fan, cheaper in the long run.

I'm not all up on Patton Model#s, but this is an older unit, correct? You may try contacting Patton (Owned by Holmes now so you may have to go through them)

If they cannot help you, try www.dtvintagefans.org There's collectors there that may have parts fans that they may be willing to sell a blade.

Alternatively, you may try Grainger, as they sell an assortment of blades. You will need to match a blade to your motor though, which should be fairly easy as the Patton fans use a common McMillan motor which most attic fans also use.

If it was wired wrong it wouldn't run. I would suspect uneven tightening of the motor screws.

If you are up to disassembling your motor, you will find a thermal cutout near the windings which frequently fails open. Replacements are readily available, or just jumper it out. If the bearings are shot or the windings burned you're out of luck. Trust me, a new motor will cost more than a whole new fan.

I have a metal blade for the Patton U2-20 fan listed on ebay. The item number is 160273949463 and the listing ends on Wednesday August 27 at 10.00 p.m. I had this fan for 8 years and the motor has failed. Patton could not replace the motor since this is a discontinued item, and I figured that someone could use another blade for their fan. I hope this helps you!

I found something on amazon, take a look here: Emerson Fans Moving Air In Style . I hope I have helped. Cheers