Washing machine noisey on final spin

Before it will start the brain needs to know the door is closed and locked. The door catch is connected to the brain - perhaps they are no longer communicating...

Something is causing the drum to be way out of balance. Does it bang and make noise when it's spinning empty? Probably not. Is something stuck on the side (inside of course) of the drum, causing it to shake when spinning? If not, a spring or shock absorber (connecting drum to sides, bottom or top of machine) has broken or come loose.

Hay Jim , sound like you need to replace ccu (main control board )good luck ,APPLIANCES R EN

solent tools 023 8057 8057 will match any carbon brush. email [email protected]

Yes they can. Search for a service manual for instructions, on the net. Parts are not usually exspensive, Repairmen are. I did mine in less than an hour.
Andy

Hey, Just load the washer but do not over load. These combo washer dryers are strictly for smaller loads. You should have a drawer to the left that you place the soap and softer and bleach. Set to the washer to washer. The door should lock automatically. Then set your dryer setting to the the Heat temperature that you want. 100 degrees is ok to start with. then it will adjust itself as it goes through the cycles you have set. Enjoy the machine should work. If it does not look to make sure that the door is closed all the way. Sometimes you have to open the door and reset it and shut the door or while it is closed gently push on it till you hear a small clicking noise. ENJOY YOUR WASHER DRYER COMBO

the trigger has been damage you have to replace it .if you want i can fix it im a technician

If it is really noisey when it spins then this can only mean one thing.... the drum bearing are shot, its a complete strip down job, not an easy job for a beginer. Sorry

No prob, the washer never draws the full 3kw at any one time.
Plz rate this solution.
thanks.

CHECK BRUSHS IN THE MOTOR