Washer is full of water and will not spin. I hear the lid switch clicking. When I start it on spin cycle I hear a hum, the tub moves a couple of inches and then stops...shortly after it shuts off.
You said,washer is full of water and will not spin. You hear the lid switch
clicking. When you start it on spin cycle and hear a hum, the tub moves a
couple of inches and then stops...shortly after it shuts off.
Some reasons this may happen
Washer won’t drain or spinn
1. Is the drain hose clogged, or the end of the drain hose
more than 72 inches (183 cm) above the floor?
2. Is the lid open? ............Also the lid switch can be faulty!!
The lid must be closed during operation.
3. Is there excessive sudsing?
Always measure detergent. Follow manufacturer’s directions.
4 If you have very soft water, you might need to use less
detergent.
Sounds to me like the lid switch can be faulty!!Then it acts like the lid is open.
Huuum
719 views
Usually answered in minutes!
×