Replace light blub in the infromation center on dash

Replace socket

I am having the same issue in my 2001 MDX. It just appeard one day. Since then it has moved. It started out on the far right and is now in the center. ???

Most often the battery cables as they connect to the battery get dirty and they can look clean and not make it so clean them anyway. If the car was jumped started wrong the main fuse can be blown and no power gets to the dash. Test light at the big power wire on the back of the altenator if its dead it's not going to start or light any of the dash lights either.

Please I will advice you take this vehicle for a scan and not to do a guess work on it.

Cheers.

if you dont have any light it could be a dash blub is out

james
G3Reseller.com

but i dont know would need more information

check blubs if the center light works should be working side brake lights

check the brake switch on the brake pedal arm under the dash.

the blub for the clock might have blown out and you will have to replace it under the dash board...

Hello scooterr1105,

If you have an all digital dash, then no, there is no light bulb to replace. It is a digital device, such as that of a calculator. While I am not familiar with these types of dashes, there may be some type of element in there that merely needs replaced. My Odemeter (milieage indicator) is lighted as such as well. I haven't had any issues with it as of yet, but I imagine there may be something to replace, rather than the whole part. I would call the manufacturer, or the dealer to research this more.

Thank you for choosing fixya.com. My apologize for not having a solution for you that would fix it.

Thank you for choosing fixya.com

carsandcomps
Guru, fixya.com
Oregon

only way to replace bulbs is to remove clocks

You will need to include more information. !. Are you referring to the turn blub in the dash or the bluds mounted in the body of the car. If in the body of the car, you need to indicate whether it is front or rear.?

If the rear, open the trunk, and in the corner nearest the tail light you will see a cloth like material that can be pulled back, which will uncover the tail light assembly. From there you can remove the blub and holder by turning it to the left or right, pull it out and remove the blub.
Bill