Washing instructions What are the three receptacles found in the drawer on the left side of the washing machine?

What!?!?

We are FIXYA dot com, we have nothing but information on how to FIX stuff! We are not who you think we are. I am guessing you are South African as they have no idea where they are posting and no one in the western world uses twin tub washing machines.

Aha, scrub most of that, you posted to Washing Machines category. A twin BED over a full BED, except where I am from they are called 'single beds' unless there are two of them side by side and then it is a twin. Two beds over each other are called bunk beds.

Wayfair for $1,500! Double bed on the bottom, a single bed on top and steps on the left. The steps are the drawers. We don't supply anything, buy direct.

https://www.google.com/search?q=twin+over+full+with+stepa+on+left+and+drawers+on+right

..

Fabric Softener Compartment Full Of Water - White Goods ...

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Jul 9, 2013 - The small fabric conditioner compartment in the soap dispenser drawer has a plastic cap or tube at the back for the water to siphon up through. ... Make sure the washer is level front to back as well as side to side. .... If the washing machinehasn't been used since there's always the possibility that the plastic ...

The fabric softener part of my washing machine drawer keeps ...

www.mumsnet.com > Topics > Housekeeping

MumsnetAfter each wash, the fabric conditioner part of the drawer is f. ... The fabric softener part of my washing machine drawer keeps filling with water ... Stopped using thedispenser compartment for fab softener and instead did I separate ... see if that clears it up and also try cleaning behind the drawer in case there is a blockage.

Washing Machine ' Fabric Softener ' Problem ' Won't Empty

Clear your filter.
Remove detergent drawer and clean the drawer and its receptacle on the machice.
Bung in 8 milton tablets in the drum and put it on the hottest longest wash you can and leave it run normally.

Run a short cold wash to flush the machine

Now put some nice smelling low foaming disinfectant in and repeat the hot wash cycle.
This should sort it but may take repeated treatments. Lower the amount of softener and detergent you use as excess can build up and can cause this problem to come back. Additionally dont overload with really dirty cloths and if you do a wash with exceptionally dirty cloths then after you empty your machine put it on a shortest rinse cycle to purge and contaminated water that is left behind.

If all this fails you will need to have your machine serviced.

If you pull out the dispenser drawer, there are usually three sections to it, the fabric conditioner one is usually on the right hand side if it is a U.K model, but other countries may vary. It will be the smallest and should have a kind of grid covering it, whereas the others will be open. If you have the instructions for the machine, it will state exactly, but I'm guessing that you don't, or you wouldn't have asked!

Instructions from Capresso:
-pull out the drawer
-look inside the unit where the drawer has been removed and look for a flap (it's really the first thing you see on the left side)
-without moving the flap, reach your hand under it and up until you feel a flat surface
-this surface will have grounds on it
-feel for screw in middle
-take paper towel and wipe off grounds
-repeat until paper towel is clean
-replace drawer and done!
-do this about once a week to prevent this

Reach under the drawer, right side and move the lock mechanism to he left. The drawer will unlock.

Three possible causes.

1. The drawer where the coffee grounds end up is not properly inserted. To fix insert drawer completely.
2. The tab on the left side of the drawer is broken off. To fix purchase an new drawer.
3. The drawer microswitch has a problem. There could be many reasons for this. The machine will have to be opened up to see whats wrong.

there is a hose from the soap drawer to the tub and this can leak. also it can be the soap box leaking. take out soap drawer and clean box and drawer. also try tilting machine back a little

We just had the same problem. We took off the three screw on the back to remove the top panel on washer. From there we took the screws off the electric face plate on the front. Be careful, there is a screw located inside the door. You must open the door to get to the screw. Next we removed the bottom panel door and then the four screws to the mail metal panel on the front. Hold that panel because the rubber gasket is still connected. Then you will see a rubber hose directly under the drawer. Take the rubber hose off at the bottom nearest the drum. We found a sock that had wedged itself up and was causing a back up. After I cleared it, the washer works just fine.

Removing the Washer Top
Three screws secure the washer top at the back of the washer. Remove the three screws and lift the top from the washer.

Removing the Console from the Cabinet
Disconnect the Touch Pad/LED Assembly ribbon connector from the left side of the Central Control Unit and release it from the wiring harness brackets on the right side of the washer top

Remove the detergent dispenser drawer by pressing down on the release tab at the back of the drawer and pulling it completely out of the washer.

Once the drawer is removed, remove the screw in the recessed hole next to the drawer opening. Release the tab securing the right side of the console to the washer

Open the washer door and place a flat-bladed screwdriver into the slot in the bottom center of the console. Push the console up to release center console tab. Be sure the ribbon cable clears the cabinet frame.

Removing the Touch Pad/LED Assembly from the Console
The Touch Pad/LED Assembly is removed as a single unit and contains the Push Buttons, LEDs, cable, etc. The buttons can be replaced separately