Replaced fan, still wont run. when thermostat is turned down, compressor and compressor fan immediately start. checked thermostat switch for continuity (checks good). where do i go from there ?
Thanks
If this is a Bev-Air, don't think the door switch will control the fan. At the evap, there is a temp sensor called a fan delay. When unit goes into defrost mode, this warms up. Some also serve a dual purpose. It will terminate the defrost cycle at a certain temp., say 51 degrees or so, at the evap. Anyway, when unit comes out of defrost, it keeps the fan off so it allows the evap to cool quicker and to prevent circulating warm air. This could be your problem. Not a hard fix but they can be a pain sometimes. Outside chance that the unit is low on refrigerant (freon). This will not let the evap get cold enough to trip the sensor back into position to turn the fan on. Good Luck. Restaurant Parts and More carry alot of Bev-Air stuff. 1-888-814-1110. Ask for Rick
589 views
Usually answered in minutes!
I also have same problem. The evaporator fan inside the won't run when I close the door. The light doesn't work neither. The compressor seem to be working, I get the cold air at the evaporator coil. If you figure out what's wrong, please post it. thanks
×