Help with my power amplifier

hi
I can't give you the schematic diagram but I might help you. What is the problem?

I think the best solution is to remove the jumpers from the Pre Out - Mon In connectors, insert a pair of RCA Y-adapters and plug one end back to the Mon In while the other ends feed the NAD (Page 15 of the manual available at Retrevo.com) . The Rotel's volume and other controls will still be in charge of the NAD.

The manual fails to mention looping the Pre Out back to the Mon In to enable the Rotel's amp to still participate in the program material.

All I can say to you is look around where the mains goes in very carefully. Fuses are sometimes hidden or in a case or cover of some kind. Sometimes amps use fuseable resistors. If the PC board is marked up look for resistors with "RF" or different indication to a normal resistor. Otherwise fuses will have "f" markings on the board. Remember the power supply part might be enclosed in a metal case with holes in it, so might be hard to spot fuses.

some amps have a switch to bridge them rather than wiring a bridge meaning output is mono check to see if yours has this switch if you do simply put back to stereo

Why would it die from being in storage? Oxide or corrosion on contacts, volume potentiometer, Tape Monitor or other switch contacts.

Try manipulating all controls and switches throughout their ranges many times and see what happens.

Check the heaphone jack. If it works so does the right amplifier. While you're at it, insert the headphone jack multiple times to cycle its contacts, too.

Sounds like wiring problems. Unhook everything, then get owners manual for proper instruction

Instead of replacing you can try and clean it. There are a lot of good contact cleaners out there.

Try only A speakers.

I'd suspect that one of the two output transistors on that channel has gone bad. If you are unsure how to test or troubleshoot this, then you might try replace both the NPN and PNP outputs and catch the bad one that way. If your amp uses an output module then you would of course have to replace the module which would replace all the output transistors on both channels. Good luck. Another thing to look out for, is the emitter bias resistors. They are the large white ceramic ones near the outputs. Sometimes one of those will open up too. They will be of a very small resistance value like .5 ohms (point five ohms) or something in that general ballpark, and have a wattage value of typicaly 5 watts. So they are pretty big resistors. Be sure to check them all even if you do find a bad output transistor. They will often go out with the transistor. Good luck.

if you say you checked the wireing ,did you check the speaker. disconnect on of the other speakers and connect up the center to see if you get sound. still no sound speakers bad. Got sound try unpluging unit for a couple of hours then try it again. still no center . Time for the repair shop. Good Luck