Hello,
I have a problem with my 55 in rear projection mitsu. I turn it on and I get a 3d effect after about 1-2 minutes of watching the tv. When it is shut off for a few minutes about 3-4 minutes and I turn it back on it is fine for the 1-2 minutes again and go back to 3d. I did notice that I still get okay color but it does only seem to have 2 colors. I have not tried to line up the colors yet due to I have never done it befor and would have to find my remote to do it. I was just wondering if I might have another issue going on with the tv.
Thanks
SOURCE: Mitsubishi vs 5051 rear projection tv sound but no picture
No video but good audio Mitsubishi VS5051. Check R509 and R 519, 100 ohm resistors located on the main PCB near the flyback transformer. Also bad connections on any of the yokes and the vertical output IC will cause the same problem.
SOURCE: Samsung HCM553W 55 in. Rear Projection Television - image duplicated
Hello, I am a Samsung TV repair man. What happened was one of your bulbs in your tv has burnt out. you have to contact your samsung repair phone line. how old is that tv? do you have a warranty? if you do, it might be repairable for free. I hope this info is useful!
SOURCE: TV screen goes blank but power stays on
Sounds like the CRTs are going into protective blanking due to the vertical output ic needing to be resolderd. Try resoldering the vertical IC that may possibly fix the issue.
Thats a common problem when the caps on the DM need replacement. They will function fine untill power is interupted then the set will not complete the boot sequence when power is reapplied and the led will just continue to blink. Hers a link to the kit that will usually repair that issue the kit comes with instructions.
http://servicemanuals.vstore.ca/product_info.php/pName/v21v19-mitsubishi-dm-repair-kit/cName/repair-kits
99 views
Usually answered in minutes!
I have the exact same problem. I hope someone out there knows what part I need to fix this. I had it fixed once before, but like a dummy I didn't pay attention to what the technician did.
what i did i went in the front of the tv and turned off the red tube and the picture is not 3 d anymore. however the color is not right. at least i can watch the tv without getting a head ache
Has anyone figured this out yet? I am having the same problem but with a concave sceen as well.
Same exact problem as above. After a few minutes the screen gets all screwey and the colors appear not to be converged. It also seems to gets worse at it moves out toward the edges. I tried the convergence settings in the advanced menu but it didn't help.
I have the same problem you describe. When I rock the TV gently back and forth it is corrected. Sometimes it works fine for hours. I have read it may be a bad solder joint and can be fixed.
×