Its the fuser unit problem in the copier get it repaired or replaced.
E000 is a high temp. error.
If this does not
help, on most units you have to start looking at your Fixing Assy. or
Thermistors. Make sure that you do not have a piece of paper wrapped
around Upper Fixing Roller or and other foreign substance in that area.
TRY TO COMPLETELY UNINSTALL THE DEVICE DRIVER AND RE INSTALL IT AGAIN..
KEPP ME UPDATED HOW THINGS GET DONE/
Hi
Turn of the printer for five minutes and then try it.
Thank you
HI
To reset these codes perform the following:
Remove the front panel and be careful not to bend or break the flexible
cable connected to the panel and the DC Controller.
Turn on the copier and short the jumper wires JP3 and JP4 on the dc
controller pcb with a screwdriver.
The count ratio indicator on the control panel turns on 'F'. When 'F'
is turned on stop shorting the jumper wires
Turn off copier and turn it back on and its then reset.
×
171 views
Usually answered in minutes!
I have a canon DB60 photo copier machine that reads...Error E000. I have tried everything by unplugging the machine, opening up & closing all areas of the machine and it still reads with an error. I can not find the owners manual. I must have either misplaced it or thrown it out. I was hoping someone with a back ground in photo copy repairs could give me some advice.
×