Clearone max ip conference phone error code 300

Hi there,

User manual pdf file can be found at: http://www.ivci.com/pdf/audio-conferencing-clearone-max-ex-installation-operation-manual.pdf

User manual pdf file can be found at:
http://www.ivci.com/pdf/audio-conferencing-clearone-max-ex-installation-operation-manual.pdf

it doesnt really have one. you will have to use the flash button to put call on "hold" or just mute call when needed.

flash will put first line on hold while a second caller is added

technically this is a one line phone and therefore no hold button was needed

power supply is bad

it is normal for echo cancelling to take a little time to get its sample and make adjustments

as long as echo is going away all is normal

I'm assuming you are using this on a 3300 ICP. In that case, the phone system is only able to do 8 party conference calls without an external Conference server.
You can dial the first number, press the flash button, dial the next number, dial the feature code (get from your vendor), repeat until you have all parties as part of the call.

The 5310 IP conference unit works much easier than this phone. A conference bridge such as Audio Web Conference with the appropriate licensing will allow for extended conference calls... it will also allow you to record the call for later "off-air" participation.

Sounds like a classic "IP" routing problem. Make sure both end points can ping each other. The other possibility is a firewall issue where the firewall is blocking the RTP (voice) traffic.

Wha???? This is an analog conference phone. Plug it into an analog phone port....

Not sure what your question is.

No most system are maxed on the phone ... but if you had a panasonic system they are know for multi conferencing.

1. Remove battery from phone, and unplug from charging cable
2. Unplug Phone base
3. Hold Page button on base and plug it back in. While holding page button wait for in use light to go solid. Once solid unplug base.
4. Hold clear button on the phone pod and plug in charging cable until you see ----- on the screen.
5. Press 0
6. Unplug power from phone pod
7. Hold clear button on the phone pod and plug in charging cable until you see ----- on the screen.
8. Hold the page button on the base and plug it in, Hold page button until the in use light blinks. Let go of page button.
9. Press 9 on your phone. If it says Reg o it is finished. If it says Reg fail try again if it fails twice please call Tech support.
10. Replace Battery
11. Make a test call