Remote doen't work with new batteries

If you just got it and it doesn't work then take it back to the shop for one that does.

It sounds like it is the receiver which is part of the fan. If that does not resolve it repost with make and model numbers.

yes i think it might be in valet

Your keyless entry system is going bad and you need a battery for your keyless entry system once you replace your battery with the new one thing should work properly

Did you replace the remote battery?

then repost

Hi,
Here is a tip about Mitsubishi Air Conditioners and how to get the manuals forall of the Mitsubishi line. The manual include both troubleshooting andinstallation.

Mitsubishi Air Conditioner Troubleshooting and Repair


heatman101

you may have a time realy wich are tied into the alarm in your car which is going out or the cars main contol the CFAP with controls the alarm functions is going out

The front key switch (or remote key sw) vol- is stuck on or has intermittent contact. It is probably the front key switch but take the batteries out of the remote to confirm it's not the remote. if that confirms it then it's the front key switch which can only be accessed by removing the entire chassis and unplugging the front keybad to check.

The battery in the 7777 remote is a CR2032. If upon changing the battery the remote fails to work then you should stand next to the car and hold down both remote buttons for around 10 seconds to reactivate it. The remotes LED will flicker rapidly during this process. Keep holding both buttons until the LED stops flickering then release both buttons. The LED should now be on constant, press the larger of the two buttons and the remote should now be re-synced.
Note: This procedure is not to program the remote to the alarm, but to re-synchronise it.

Fan is controlled by a temp sensor on Mobo and by CPU. I hard wired my "dead" fan to a constant 5V power supply (off the battery bus) and now it runs constantly, doesnt bother me and I have yet to lock up. My CPU cover actually discolored and warped because my fanless CPU got so hot!