Will not start

Do you have spark to plugs? Correct fuel pressure? Injector pulse? Compression?

Time for a valve adjustment. You have done the right thing by replacing the spark plug and cleaning the carb. Check your valve cleareance and make sure is up to specs.

For spark plug problem, click the help links provided below: ---
Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

------------
How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

-------------
Car cranks, has spark but will not start?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

------------------------
The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

----------
How to gap spark plug ? http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------
Spark plug Replacing for?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

-----------
How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

---------
How does the spark plug wire go on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

---------
Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

-----------

This will help.

Thanks.

If it doesn't fire right up do not keep trying you will burn up the starter Change something
1.Fuel on
2 kill switch to run
3 side stand up
4 petcock in prime position if it has one
5 Spark?
6 choke on?
7 check the spark plug to see if it smells like gas or is wet with fuel
20 seconds at a time on the starter or it will burn out

gonna have to pull the head if something is hitting the park plug. check and make sure the proper head gasket is installed and that you are running the proper spark plug. also when you have the plug out put your thumb on the hole and have someone kick it, the pressure should force your thumb off the hole, if it doesnt, its time to redo the top end.

buy a dodge!

In servicing the spark plug . If the owner will be the one to change the spark plug then. the owner should locate the spark plugs . then prepare the equipments that is going to be used to change spark plug .First disconnect the spark plug cable to the spark pug . Then use the equipment to take the spark plug off to the engine. The spark plug should be twisted counter clock wise using the equipment to remove the spark plug.Then replace the spark plug.In returning the spark plug ,using the equipment you have to twist the spark plug clock wise . Then set the distributor shaft turn it according to the proper firing order that will be set to the spark plug if it is 1,3,4,2. Then the distributor shaft mark will be on 1.If 2,3,4,1 then the distributor shaft mark will be on 2. Then connect the spark plug cable , after connecting the owner have to test start the car so that to if it back fires .If it back fires then the owner have to repeat again the setting of the firing order of the spark plug until it will not back fires.If the owner don't have time to do the job in servicing or changing spark plug then the owner have to go to a car mechanic and let them change the spark plug.

de decompressor as to be there....those four stroke need a good kickstart to fired ( without decompressor can broke you're kickstart pedal or hurt you badly..) i sugest you recheck valve clearance and make sure the timing is done when you are at top death center and you're exhaust cam is about to be open shortly after top death center.( that means you are in the right position to align the mark on both cam to each side of the head....also you can check out for fire problemme ( timing or firing at wrong time) you said it as fire then just put gaz into the spark plug hole (a spoon) then it should start right away or try to....then if it wont start you know carburation is not an issue because you by pass the carb by injected gaz right on top of piston...then only thing left is fire and compression...if you have all that one with care....let me know ill find away to make that things [email protected] .....stephane.

Yes the oil can cause the car to lose spark, the oil leak could be caused by the valve cover gaskets around the spark openings, but 9 times out of 10 it is the spark plug tube "O" rings. The top of the valve train comes off of the head, the "O" rings are between the two halves, that will fix the oil leak.