Proform 12.5 it starts then just stops

Question edited for clarity, 'then; a moment in time, 'than', a comparison between one thing and another.

It is a known issue on Proform. Help in the link.

https://www.google.com/search?q=Proform+510i+treadmill+starts+then+stops

..

https://www.helpowl.com/ProForm/AllSupportQuestions

check adjust belt tension
may have to clean under belt area as there could be a build up that is stopping the free movement of the belt as it gets hot

1) Please LUBE very well the deck belt, with Silicone.
2) Test the thermo switch inside of motor, for overheating.
3) Test with Battery 12 Vdc fro Motor Cycle, for to see if the motor is o.k
4) If everything is o.k the Controller Board Motor is Faulty, the IGTBs is faulty. Replace.
5) See if the walking belt when you lift with his finger has 2-3" otherwise fit with allen screw rear, see the instruction manual how to do it.
Blessing.
Adjust Walking Belt Tension
[email protected]
cell+whatsAPP:+50588611441

It sounds like the control board. You might find it on eBay.



Proform Crosswalk Treadmill eBay

Proform Crosswalk 345s 831 294030 Fitness and Exercise Equipment Repair...

PROFORM PROFORM CROSSWALK 345S Parts Model 831294030 Sears PartsDirect

PROFORM PROFORM CROSSWALK 345S Parts Model 831294030 Sears PartsDirect

How can I get my Proform 320X treadmill from stopping a ...

www.shopyourway.com > Manage My Life > Questions
How can I get my Proform 320X treadmill from stopping a few seconds after starting? ... -why-does-my-proform-treadmill-belt-only-move-a-few-seconds-stops

ProForm Treadmill 320x User's Guide ' ManualsOnline.com

fitness.manualsonline.com > ... > ProForm Treadmill
ProForm 320x Treadmill User Manual. Page 1. Page 2. Page 3. Page 4. Page 5. Page 6. Page 7. Page 8. Page 9. Page 10. Page 11. Page 12. Page 13.

please see the video attached. lube the rollers bearing front+ back
2) test the input terminal voltage motor, if there ARE the motor is faulty. see my personal TIPS for motor help 3) test the output voltage board, if there ARE NOT voltage for input voltage MOTOR, the board is faulty.
God bless you

LUBE the deck belt and rollers bearing this happen to due the lack of maintenance. see the video attached. Do it with silicone or wax read your manual.
If after you did lube the problem remain, TIME to replace the old board deck belt.
God bless you

My tredmill wont unfold - i dont know how? Help??

Most likely a bad drive belt. Take the cover off the motor area. If you see black dust near the left side of the motor, replace the drive belt.