I have a roper washer 5 years old and it won't drain or turn on now it was working fine yesterday ive unplugged replugged pulled out all the clothes checked power supply and hoses what now?

The pump went out. When a washer doesn’t drain it won’t spin either. The problem is the pump isn’t working. This could be a easy fix. When clothes are loaded, a sock or a small item can accidentally slide over the wash tub and land in the outer holding tank. The pump will pull down the sock and clog the pump from a hose connected to it. Separate the pump from the hose and you might find a handkerchief, small rag or sock inside.

first pull out the plug
check the filter and drain pipes are not blocked

That is still under warranty, you have done all that you can within reasons. Call Lowes.

did you tryed anything els?

the transmission

could be the transmission or the drive motor to transmission coupling. You say the agitator doesn't work but it washes fine please clarify your problem.

Dear customer

Please perform the following checks

This may be a spin problem or a drain problem
Drain:

• Make sure the drain line is clear
• Check the drain hose for a partial blockage
• Inspect the water pump

Spin:

• Test the lid switch
• Test the timer control
• Test the centrifugal switch
• Test the water level switch
• Inspect the motor coupler
• Inspect the drive belt (belt drive only)
• Inspect under the washer for soot (clutch)
• Test the motor
• Inspect the pulley
• Test the transmission

Please rate this,Thank u

I am having the same problem with my washer. Go to this web site below it has a free troubleshooting guide. I narrowed my washer machine down to two parts. Stator assy or Main PWB assy.


http://136.166.4.200/contents/Laundry/WM2042/WM2042xx_Service_Manual.pdf

if the drive coupling is ok then the transmission is the problem verify for sure that the coupling is good