I have disassembled this machine as far as I dare, which is pretty far. Bought it knowing about E6 message but even though it had lots of lint, I've cleaned it out completely, the only thing I can't get at is under the metal bobbin case holder. Wheel turns, but very hard. I don't think it's value merits a professonal. Am thinking maybe the wrong lubricant? Part of a broken needle? Bent shaft?{maybe fabric was pulled out too hard?}Please help.
Needle Position Sensor is disconnected
This sensor detects the drive timing for the pulse motor for
zigzagging and feed, the vertical stop position for the needle. It
detects the upper shaft angle of rotation using a shutter attached
to the upper shaft and an optical sensor.
See HERE for Service Manual
SOURCE: My CS-6000i - handwheel will barely turn error message E6
just had same problem oil it, there is a little hole on top of machine close to the bobbin threader drop some oil in there to oil the motor. turn the wheel may take several drops and a couple of applications....thank god my mom can sew too...lol she found the problem!! My manual is in spanish and I am american born and only speak and read english.lol
340 views
Usually answered in minutes!
×