I need the circuit board diagram for a sony trintron xbr 36" tv

No. Ofcourse not.

Hello,

Your power supply board is dead, do you know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

I hope this will help in solving the problem..

This is according to the sony service manual

Five blinks - AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.

Sounds like a failure in the C Board or AKB Circuit.

Best to take it in to a service center.

hi
low voltage overload A or B board ic 6007 defect

do you have any audio? if you do the it's usually a fuse for the video circuit. if no sound no picture, then main fuse power supply out

looks like a horiz.output transistor is shorted.check it...

i need a rc gide

The 6 or 7 blinks usually indicate a problem in the horizontal circuit. Since the TV recovered once, the problem is most likely to be a bad solder connection in that area. If you can solder, resolder any connections on the board that appear grainy or have rings. That may resolve the problem. If not, update this and we'll look elsewhere for defective parts.

Dan

The standby light should be blinking a repeating count with a 2 second pause between counts. Can you post hte count here please? That will help to determine the effected circuit and the solution.

Thanks,
Dan

You may have to replace D6116 and D 6301 on the "G" board.