Tv stuck on channel 12

hi

are you changing channels on the remote or on the tv?

take the batteries out of the remote and try and change the channels on the tv. if you can change channels fine on the tv then the remote buttons are stuck. usually in the battery area on the remote is a small screw take that screw out and disassemble your remote and use a q tip and rubbing alcohol to clean out your remote

I was able to do this by using the down arrow on a visio generic remote. The functions are not there but, it resets, does a channel check, and defaults to manufacturers settings.

you can use the remote controller to select the game mode.

Hello
Your sanyo TV has no menu button on its front panel control. Without its original remote, it is immpossible to get ito its AUX. OK.

you could hook a cable box/ freeview box/ satellite box to video 2 and use that for channels?

If you use a tv dish or cable box you could program the cable or dish remote to control your tv. Look up the codes online

A POSSIBLE solution. I have the same stet...got it used, but it's in good condition.
It was stuck on a channel. I went iinto the menu and fiddled with the channel programs and "deleted" the channel and now I can freely change channels.

By the way, I could use a manual for this ...got one?

Yippie, I figured out a solution that worked!!! I have a univeral remote from comcast, on that remote near the bottom left is a small button that says (input) tv/vcr, press that one time and whala!! the tv video screen was gone, I had to manually change the channel from the tv channel button on the unit. once I changed the channel to 3, my universal remote worked... the button is the second one from the bottom left... I was on hold with sanyo for a long time and just kept trying on my own, so good luck!!!!

you can play your PS2 via the RF in (ANT IN ) at the back of your TV .
For this you will first have to connect a AUX to RF converter jack device to ANT IN jack of TV.
Then determine the OUTPUT CHANNEL of the PS2.
(Channels-1 to 12 is in VHF band
channels-21 to 69 -UHF band)
Put the PS2 "ON"
TUNE the TV set to the frequency of PS2.

Universal Remote should do it.