I need a wiring diagram for a pro form 730 treadmill

Dear Sir:

Adjust the reed switch, attached is the diagram, clean with special spray contact , and tight the wires.
specially the flexible cables from keypad.

Run the software calibration for easy diagnose and troubleshooting and fix it.

sincerely. God bless you.

Dear Sir:

Adjust the speed sensor very weel see the diagram attached, tigh the connector wires very well, and clean the s. sensor very well.

2) Run the software calibration for easy diagnose , fix it, and trouble.according with your manual instructions.

sincerely. God bless you.

ernesto cuadra
managua, nicaragua.

This conditions indicate belt speed loss. To due any motor, wiring , or motor controller failure.

check this:

Watch this videos tips:
http://www.youtube.com/watch?v=qgb2TY3WCkg&feature=related
http://www.youtube.com/watch?v=-oeXTKqWECw&feature=related
http://www.youtube.com/watch?v=GPI6dFJCUA4
http://www.youtube.com/watch?v=bF3OyQ3HwfU&feature=related
http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitness
http://www.fixya.com/support/r10786838-test_procedure_dc_motor

hi,
I have the manual of Pro Form 730si . If you can give your email as a replay for this then i will sent the manual to your email id. I can't upload the manual through fixya. Because its a pdf file.
OK

If you have not lubricated the deck I suggest you doing so you may purchase the lube @ Gymparts.com Part # TM001

Please check out this tip I wrote.

Wondering if you found a solution to this problem yet? I seem to have the same situation with my 730cs treadmill. It is inclined and will not move up or down...thanks.

loosened the drive belt from the motor to the track

Did you find a solution for this issue? I have a similar situation