Toner light stays on after replacing toner - Office Equipment & Supplies

Is nothing to reset, you must verify if the toner sensor is not dirt with toner. Best regards,

replace the toners as indicated.

it may be not a genuine one, or you have a paper jam inside the printer

Hi,

If the main problem is just the toner light on then what you could do after installing the new toner is resetting the printer. You could do that by powering the printer off, open the front cover (as if you were to replace the toner) with the front cover open and the printer off push and hold the two buttons on the printer and turn the printer on while holding down the buttons then once the bottom light stays on solid, release the two buttons and that should reset the printer.
Now if the toner light is blinking that means that you have reached the 30,000 page mark and the Photoconductor needs to be replaced. If that is not the case you can follow this link to a procedure where it will explain how to reset the Photoconductor. http://bit.ly/91SWS3

Keep opening and closing the front door until the toner catches up. Did it have a plastic seal that you forgot to pull off?

well it may need to be completely reset or you could try seeing if it is jammed or stuck in some way

Open the front of the printer then hold down the cancel button. When the lights flash close the front and it should Reset.

how do i set the toner reset lever on a brother hl 5250 printer

According to the operation manual: If alarm light and data light blink every 5 seconds- TONER LOW (purchase more toner and have it ready when the 'toner empty' is indicated). If alarm light and data light stay lit- TONER EMPTY (replace toner cartrige with new one).

[email protected]