How do you replace the breaker on a tc5000 treadclimber

https://www.fixya.com/support/t2438337-bowflex_treadclimber_calibration_failed

https://www.manualslib.com/manual/612664/Bowflex-Treadclimber-1000.html?page=34

https://manualzz.com/doc/871362/bowflex-treadclimber-1000-service-manual

Hi.

Please click on the link to view how to calibrate the treadmill.


https://www.manualsdir.com/manuals/58333/bowflex-treadclimber-5000-treadclimber-3000-treadclimber-1000.html?page=33


Kind regards.

Hi, if you have burnt electrical smell and the breaker keeps tripping you have a short in the motor that's what causes the tripping in the breaker. You will have to get it repaired or claim if it's still under warranty.

You have to call the Company representative who will guide you through the error code. Call :1-800-628-8458
In case you don't have the manual, here it is: http://www.searspartsdirect.com/partsdirect/user-manuals/TC5000-Bowflex-Parts-BOWFLEX+TREADCLIMBER-manual

Good Luck!

If you're running the machine on a dedicated circuit then your unit is drawing too much current. This can be caused by friction and drag. Solution: Lube deck/belt. If problem persists, replace deck/belt. If you ignore this fix this will blow your controller. .

see the video attached. and proceed according. However you must test the power cord for short circuit. some wires is touching each to another. Or the outlet wall the wires are loosing touching each to other and blowing the c.breaker, or call some electrician for to fix it.
God bless you

test the power switch for defective use the vom
2) test the c. breaker for defective use the vom
3) test the power supplier see the diagram attached.
God bless you

see the video and proceed according and fix it. God bless you

Try again RUN the software calibration. and adjust the REED SWITCH, and Speed Sensor, test it, clean it, and tight the plug or connector from UPPER board vs lower board.
God bless you

Here is a GREAT FIXYA Post from 2013 that addresses your error code, "L5"

TREADCLIMBER tc5000 error code L5

Anthony