Xt140sb john deer pull string 2-cycle gas trimmer, low rpms, what should i do

available from JD mower shops or e-bay on line

Contact the consumer desk.

TB22 EC Curved Shaft String Trimmer by Troy-Bilt

www.troybilt.com/.../troybilt/TB22EC-trimmer

Troy?Bilt Products
Rating: 3.7 - ‎232 votes - ‎$99.99 - ‎In stock
25cc, 2-Cycle Gas Trimmer / Attachment-Capable Design ... The TB22 EC gas string trimmer is both JumpStart™ and TrimmerPlus® attachment capable, making ...

Gas Trimmer ' TB635 4-Cycle Curved Shaft ... - Troy-Bilt

www.troybilt.com/.../troybilt/tb35-ec-curve-shaft-gas-...

Troy?Bilt Products
Rating: 3.3 - ‎32 votes - ‎$179.99 - ‎In stock
The TB635 EC curved shaft gas trimmer with SpringAssist™ technology features the new Click N Trim™ bump head, making line replacement easier than ever. ..... next one they put on - will only run for about 4 seconds. they've had for about 2 ... Both String Trimmer and Edger work great, easy to start and very low vibration.

Compression issue. Check it with a 2 cycle compression gauge.

Your String needs to be re-wound. You are almost out of string or your string has Jammed under the Motor and placing a DRAG on the Trimmer

On the carb. Low for initial and high for top end. Start with both at 2 1/2 turns out. Then adjust low when you pull the trigger to eliminate hesitation. Then floor it and hold while you adjust the high

http://manuals.deere.com/cceomview/OMPS05249_J2/Output/Index.html?tM=

Have a JD T105C trimmer that starting "spitting gas out of it" when i try to start it!! It won't start and when it DID, it stalled right back out! Was used VERY LITTLE before this happened!

I have the same problem. I replaced the primer bulb, and the fuel lines. Still no gas to the bulb; (It ran fine before I replaced the primer bulb)

a safe mix is 25:1 but the correct mix for that machine is 32:1

your motor has an airleak..in the cranckcase..it could be warn out piston rings...must be an old unit