Kx-tg5634m display screen does not show anything--blank

Hi,

please power cycle the phone unit and check for the display screen when it's on the base again. If still having the issue, please attempt a factory reset of the device. Then, you can setup the phone just as you did when it was brand new. Otherwise, you might have to keep the receiver off of the display in order to allow the screen to show data as it used to.

Thank you.

I am guessing that the display screen is broken and not working and has to be replaced here.

unplug your phone and plug back in, mine does this all the time- is it a remote hands free ???

refer to the website

Hello,

You would need to change the screen. Go to a phone repair shop to assist you in changing the screen. It will cost you a little.

Best regards

There seems to be a problem with your display screen or the connection might be loose. You phone care be repaired from any Panasonic or electronic shop as the problem is not that big. The screen display might need to be changed or the repair person will fix the internal connections because of which also the display might not be there.

There are different reasons this could happen: 1. The connector from your phone's mainboard and your display LCD is damaged. This means you either have to change the connector or your LCD entirely. 2. There's a display IC that's damaged. You'll need to take it to an expert or the manufacturer's repair center. They should fix it for you.
Before you get it fixed, inquire about the cost involved and see if it's economical enough to warrant it. If it costs more than the phone is worth, get a new one :)

I am having the same problem with my KX-TGA234W. One day the screen just went blank, so I changed the battery, but it still is blank. I hope that someone can help both of us.

Problem has been solved. I was able to locate a Panasonic manual for our quad phone. Sorry to have troubled you.
Thank you.

Since, by default, you have either 4 or 8 lines minimum, do they appear on other phones and is there anything on the buttons? Press PROG and line 3 button. If the display shows CO 003, you have another problem. If they show blank, dial 0 3 and press ENTER. Do the same for line 4 (using 4, of course).

Carl